List of Companies Using the Advidia Products
+ View more

A-200-P
2MP - PTZ Speed Dome with 20x Optical Zoom Lens with POE

The A-200-P is a 2 megapixel speed dome with 20x optical zoom. With built-in motion tracking and touring capabilities, the A-200-P is perfect for watching parking lots, stadiums, or any other wide area. With the 20x optical zoom, grabbing even the most minute detail is not a problem.

Request More Information
  • POE
  • Up to 2 megapixel resolution
  • Progressive scan CMOS
  • High Speed PTZ
  • 20x Optical Zoom
  • Weather Proof Rating: IP66
  • WDR and auto/manual day & night switch
  • Standard H.264 video compression with high compression ratio

Technical Specifications
Image Sensor 1/3” Progressive Scan CMOS
Min. Illumination 0.05Lux@F1.6
Shutter Time 50Hz: 1/25-1/10,000s, 60Hz: 1/30-1/10,000s
Lens 4.7-94mm, 20x optical zoom
Angle of View 58.3-3.2 degree (Wide-Tele)
Mount Options: Long-arm wall mount, Corner mount, Pole Mount, Power box mount
Pan Range: 360° endless
Day & Night IR cut filter with auto switch
Video Compression H.264 / MJPEG / MPEG4
Dual Stream Yes
Max. Image Resolution 1920 x 1080
Alarm Trigger Motion detection, tampering alarm, network disconnect, IP address conflict, storage exception
Protocols IPv4,HTTP,HTTPS,802.1x,Qos,FTP,SMTP,UPnP,SNMP,DNS,DDNS,NTP, RTSP,RTP,TCP, UDP,IGMP, ICMP,DHCP,PPPoE
Power Supply Hi-PoE: 40W max (heater: 20W) Hi-PoE Injector Included, 24VAC: 65W max (heater: 45W)
Sample Picture Quality (Hover over image to see quality)

Sample Video Quality (Go Full screen to see actual quality)
Mount Options:

A-200_CM

A-200_LPM

A-200_PM

A-200-CNR

A-200-WM

A-200-Parapet

A-46-PM

A-200-CLEAR-DOME

A-200-IFM

A-200-SMOKE
Support Guides
Installation ManualDownload [PDF]
User ManualDownload [PDF]
A&E Spec SheetDownload [PDF]
Customer Review
Product ReviewRead Review [URL]
Firmware Downloads
Firmware InstructionsDownload [PDF]
Firmware InstallDownload [ZIP]
Special NoteSecurity Update: V5.3.0 build 150608 To 151209V5 should be updated to V5.3.0 build 170317. For A Series cameras, a factory default is required after upgrading the firmware from 5.1.2 to 5.3.
Customers who view this item also view: